All products

Ruler at the edge of the work area is used to align workpieces in the work area

Moves the engraving head horizontally

Moves the engraving head horizontally

Motor used to raise and low the work surface

Moves the gantry from near to far

Symbolic interface keypad

Best for detailed cutting

Operates the X-Axis, connecting the engraving head to the X-Axis motor

Laser Calibration

Photo processing software - All Systems

Used in both the X and Y axis to determine maximum movement of the axis

Moves the gantry from near to far

Switch component that allows the laser to be active when door is closed.

Helper springs are used when you pull open the front door

Motor used to raise and low the work surface

Moves the engraving head horizontally

Motor used to raise and low the work surface

Soft foam gaskets that ensure a tight fit around the table

Moves the gantry from from near to far

Connects the control board to the X-Axis PCB and transmits motion control commands and data

Multifuntion harnes used to connect key components

Mirror used to steer laser from source to lens

The Carriage Assembly moves along the X-Axis holding the final steering mirror and focal lens.

Harness used to connect the Rotary to the Zing System

Seals the periscope optics from debris.

Best for detailed cutting

Motor used to rotate the wheels on the Rotary

This board controls the motor (RC0912) in the Zing Rotary